BCER Lifts Suspension for Water Sources in the North Thompson River Basin (DIR 2023-11)

Water use suspensions are lifted for all water sources in the North Thompson River Basin, while suspensions for other water sources listed remain in effect.

DATE ISSUED: Nov. 6, 2023

EFFECTIVE DATE: Immediately

With increased precipitation in parts of B.C., the BC Energy Regulator (BCER) is lifting the suspension for all water sources in the North Thompson River Basin, including:

Nehalliston Creek
Eakin Creek
Lemieux Creek
Montigny Creek
Thuya Creek
Noble Lake
Jamieson Creek

Water use suspensions for all other water sources below remain in effect at this time:

Fraser River Watershed:

Salmon River
Thompson River Basin:
- o Coldwater River

Peace River Watershed:

Beatton River (Doig River, Osborn River, Blueberry River)
Kiskatinaw River
Pine River (Sukunka River, Murray River)
Pack River

Liard River Watershed:

Fontas River
Sikanni Chief River
Prophet River
Kiwigana River

Diversion and use of water stored in dugouts or dams is not suspended. Basins across B.C. are being monitored and further suspensions of water diversions are possible if conditions continue.

Given local variability, it is possible some streams in the areas under suspension will have recovered sufficiently to allow some water withdrawal. The BCER will review new applications for diversion, or requests to use existing approvals, on a site-specific basis.

Permit holders can discuss the suspension with the BCER and submit a request for continued water use under an existing Section 10 approval, by providing location-specific data and subject matter expert opinion relevant to local streamflow conditions.

Operators are requested to do the following to support their application or request to use an existing Section 10 approval:

Limit the application to water volumes and points of diversion that are realistic to the specific operational needs for the upcoming months.
For new applications for diversion for water from rivers and streams, or to request use of existing approvals, provide a good discharge measurement at the point(s) of diversion, to provide information on current flow conditions in relation to the volume of water requested. The discharge measurement will be collected to an acceptable hydrometric standard by a qualified individual.
For new applications for diversion from lakes, or reactivation of existing approvals, provide information on lake bathymetry:
1. Surface area (hectares).
2. Depth (metres). If lake depth information is not already available from provincial databases or previous surveys, obtain depth measurements at points along two transects representing the long and short lake axes, to determine maximum lake depth.
3. Volume.

More information: